Hardware points

As of Mervis IDE 2.3.0.x, for the FreeRTOS platform there is load evaluation as HW points (which is just a measure of processor and memory load, these hardware points have nothing in common with physical data points - inputs and outputs). The HW points add with added channels and devices. After compilation, the HW points utilisation is listed in the Output tab. 

overview of hw points for plc with freertos operating system:

plc softplc link iec 62056-21 m-bus bacnet udp bacnet udp server modbus serial modbus tcp modbus server serial modbus server tcp
mark100 - max. 119 p. 30 p. (+2  p. per device)34 p. 34 p. Protocol not supportedProtocol not supported29 p. 29 b. (+2 p. per device)27 p. 29 p.
mark100v2 - max. 119 p. 30 p. (+2 p. per device) 34 p. 34 p. Protocol not supportedProtocol not supported29 p. 29 b. (+2 p. per device)27 p. 29 p.
mark120 - max. 94 p. 30 (+2 p. per device) Protocol not supportedProtocol not supportedProtocol not supportedProtocol not supportedProtocol not supported30 (+2 p. per device) Protocol not supported30
mark125 - max. 443 p. 30 (+2 p. per device) 30 34 24 23 30 30 (+2 p. per device) 28 30
mark150 - max. 118 p. 30 (+2 p. per device) 34 34 Protocol not supportedProtocol not supported30 30 (+2 p. per device) 27 29
mark150s - max. 119 p. 30 (+2 p. per device) 34 34 Protocol not supportedProtocol not supportedProtocol not supported27 (+2 p. per device) Protocol not supported29
mark150/485 - max. 118 p. 30 (+2 p. per device) 34 34 Protocol not supportedProtocol not supported30 30(+2 p. per device) 27 29
mark150/485s - max. 118 p.30 (+2 p. per device) 34 34 Protocol not supportedProtocol not supported30 30 (+2 p. per device) 27 29
IMIO100 - max. 118 p. 30 (+2 p. per device) Protocol not supportedProtocol not supportedProtocol not supportedProtocol not supportedProtocol not supported30 (+2 p. per device) Protocol not supported30
IMIO105 - max. 466 p. 30 (+2 p. per device) 30 34 24 23 30 30 (+2 p. per device) 28 30
IMIO110 - max. 443 p. 30 (+2 p. per device) 30 34 24 23 30 30 (+2 p. per device) 28 30
ICIO200 - max. 114 p. 30 (+2 p. per device) 30 34 24 23 30 30 (+2 p. per device) Protocol not supported30
ICIO205 - max. 466 p. 30 (+2 p. per device) 30 34 24 23 30 30 (+2 p. per device) 28 30

If the maximum recommended amount of HW points is exceeded, the warning can be ignored by checking Ignore points in PLC properties, and redeploying the project. However, for correct and safe PLC operation, this is not recommended. The PLC may lack resources for other processes, and e.g. web server response may be worse.