Differences
This shows you the differences between two versions of the page.
en:mervis-scada:90-how-to:45-alarm-sms [2018/03/28 12:56] m.chlupac [Alarm SMS] |
en:mervis-scada:90-how-to:45-alarm-sms [2018/03/28 13:56] |
||
---|---|---|---|
Line 1: | Line 1: | ||
- | ====== Alarm SMS ====== | ||
- | The user can be informed by SMS about change of the state of the alarm point. | ||
- | |||
- | SMS text can be defined by user, but in most cases is used a default form, which includes: | ||
- | * **confirmation code** (usually a letter and a few digits) | ||
- | * the time at which the reported alarm condition occurred | ||
- | * project and data point name | ||
- | * the value of the data point | ||
- | |||
- | |||
- | The user can acknowledge an alarm, if he has sufficient rights to do so, by sending an SMS to the phone number, from which the message was originally sent. | ||
- | |||
- | To acknowledge the alarm, it is necessary to write the keyword **ok** followed by a space and the received confirmation code. E.g.: | ||
- | < | ||
- | |||
- | After successfully processing the command, a confirmation SMS is sent to the user summarizing which alarm has been confirmed. | ||
- | |||
- | ===== Example ===== | ||
- | |||
- | |||
- | {{ : |