Mervis/Merbon SSCP

The Mervis Proxy is the solution for communication from non-public or “hostile” network environments. It allows fully transparent communication over the Internet among controllers or communication with other clients, like supervision systems (e.g. Mervis SCADA).

For maximum compatibility standard encrypted communication via HTTPS (or HTTP if required) is employed and therefore Proxy Server can be freely used in most network environments.

The Proxy Server supports standard data communication and also almost complete engineering capabilities needed during the installation of the control system and building commissioning. Greatly reduced cost and much smoother tuning of the control system are just few of the apparent benefits.

Mervis Proxy is fully compatible with Merbon system!

Parameter Value
Address for PLC communication encrypted - https://proxy.mervis.info:6678/
or http://proxy.mervis.info:6677/
Address for client communication (SCADA, Mervis IDE, Merbon IDE, …): encrypted - tcps://proxy.mervis.info:12348
or proxy.mervis.info:12348
ProxyID: Contact technical support Mervis nebo Domat
Communication Protocol: SSCP

Settings in IDE

Enable Mervis Proxy communication and upload configuration to PLC. Don't forget to configure DNS server parameter in network configuration.