Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
en:mervis-ide:40-mervis-rt [2019/09/25 12:56] m.chlupac [List of supported platforms] |
en:mervis-ide:40-mervis-rt [2026/09/08 09:44] (current) m.chlupac [Wago] |
||
|---|---|---|---|
| Line 1: | Line 1: | ||
| ====== Mervis RT ====== | ====== Mervis RT ====== | ||
| - | While Mervis IDE allows you to create the control logic - Mervis RT (runtime) | + | While Mervis IDE is used to define |
| - | ===== List of supported platforms | + | ===== List of Supported Platforms |
| - | * Domat: Mark controllers, | + | ==== UniPi ==== |
| - | * UniPi | + | |
| - | * Wago | + | |
| - | * Controllers | + | |
| - | * PFC200 - 750-8202 | + | |
| - | * PFC100 - 750-8101 | + | |
| - | * PFC100+UART - 750-8102 | + | |
| - | * Modules | + | |
| - | * 750-430, 8x DI | + | |
| - | * 750-451, 8x AI RTD conf | + | |
| - | * 750-453, 4x AI 0-20 mA | + | |
| - | * 750-530, 8x DO | + | |
| - | * 750-559, 4x AO 0-10 V | + | |
| - | * 750-600, End Module | + | |
| - | * 750-638, 2x up/down counter | + | |
| - | * 750-652, 232/485 conf | + | |
| - | * Raspberry PI: on request | + | |
| - | * Windows: on request | + | |
| - | * general Linux: on request | + | |
| + | * All models | ||
| + | ==== Wago ==== | ||
| + | For installation instructions, | ||
| + | {{section> | ||
| + | ==== Raspberry PI ==== | ||
| + | * Available on request | ||
| + | |||
| + | ==== Windows ==== | ||
| + | * Available on request | ||
| + | * [[en: | ||
| + | |||
| + | ==== Linux ==== | ||
| + | * Available on request | ||
| + | |||
| + | ===== Extensions ===== | ||
| + | * [[en: | ||