Table of Contents
REPLACE
Function name
REPLACE
ST call
PROGRAM REPLACE_DEMO VAR IN1,IN2,OUT1: STRING; L1, P1: INT; END_VAR OUT1:=REPLACE(IN1:=IN1,IN2:=IN2,L:=L1,P:=P1); END_PROGRAM
Description
The REPLACE function replaces part of the input string in1 by another string, in2. The starting position “p” must be greater than 0 and less than the total number of characters in the string in1. If the replaced part is out of the input string, it is a input parameter error. If the “l” and “p” values are entered falsely, there is an exception and the PLC stops. If stop on exception is disabled, the function output gives the last correct value.
Inputs
| Input | Type | Description |
|---|---|---|
| IN1 | ANY_STRING | Input string, of which a part will be replaced |
| IN2 | ANY_STRING | Input string which will replace the omitted part |
| L | ANY_INT | Length of the deleted part |
| P | ANY_INT | Position where the deleted part starts, if at the first character, p=1 |
Outputs
| Output | Type | Description |
|---|---|---|
| ⇒ | ANY_STRING | Output string |
Example
